Import should be necessary for conventional blades in use and when not in use and maintenance, so it can extend the use of imported saw blade milling cutter for cutting length and enhance the quality of the cost control, can save a lot of cost.
Saw blade maintenance, generally divided into two parts, part of the use of pre maintenance, part of the use of the maintenance, the specific analysis is as follows:
First, before the use of imported milling cutter maintenance
Many people think that the blade after use, strict maintenance operation in accordance with the relevant provisions on it, but they do not know the blade also need to maintain before use, and it is also very important, the specific maintenance content as follows:
1, saw before use, must first be equipment idle for 30 seconds, it can check whether the device is in normal state, this step is very important, many enterprises have not implemented, factors often imported saw blade milling cutter using instability is the cause of instability caused by equipment.
2, the internal equipment clean, prevent the residual fine iron, if not cleaned in time, there will be a great possibility of fine iron into zigzag inside, causing cracking or collapsing parts of saw blade saw tooth tooth phenomenon.
3, equipment when idling, listen to the voice of the imported cutters, issued under normal circumstances the sound is uniform, if there are noises, should stop check.
Two, after the use of imported milling cutter maintenance
After the saw blade is used or the equipment stops working, it is necessary to carry out some necessary maintenance work:
1, brush carefully will clean up work and pay special attention to the saw blade sawtooth part in zigzag in the small iron, it is also the most easily overlooked place.
2, check whether there are signs of imports, such as loose spots, including sawtooth, see if there is no crack, etc..
3, observe the surface of the workpiece last sawing, whether normal, such as texture, burrs and other, if there is too much grain enhance or burr etc., should be carefully checked to see saw, grinding is not required, or equipment maintenance.
4, do not use the blade, should be placed in accordance with the provisions, the specific operation can refer to the "carbide saw blade maintenance"
Summary: no matter what kind of saw blade milling cutter, must always maintain the necessary maintenance work, only in this way can play the role of the saw blade, can prolong the service life and improve the quality of sawing!